Comments
-
That is an industrial network with statically assigned IP addresses. None of the devices have a gateway assigned. Is it possible to connect without a gateway? I could assign an address range on the control network if that would allow communication.
-
I found that the user did not have access to the correct subnet. Here is my packet monitor after fixing that.
-
@MustafaA I factory reset the router and ran through the setup again. Now I can connect with my phone, but I can't access an internal website hosted on my control network. The IP I'm trying to connect to is 192.168.10.7. If I connect my laptop directly into that network I can access it. Thank you for your helps so far.…
-
I enabled the WAN Zone. Now the VPN status is stuck at connecting on my phone.
-
I did a factory reset and reconfigured it with the same result. I have a control zone with static IPs. The router is 192.168.10.1 I created an IP Pool Setup the VPN Server: The policy was set automatically. Setup a user I am connecting to the VPN server on 192.168.39.148.
-
@A_Elliott I think it is just a self singned cert. @MustafaA I can connect with the Global VPN client with those credentials.